More information is available at Plumb2U.
When sourcing a replacement, the button, spindle or cable and flush valve should be treated as a connected set rather than assumed to be interchangeable across brands, since fixing centres, spindle diameters and cable lengths vary between manufacturers. Plumb2U stocks dual-flush buttons, spindles, cables and the flush valves they operate, at trade prices, so a plumber can source the whole linkage in one order rather than guessing which single part will solve a button that has stopped working properly. Checking the range at a plumbers merchants like Plumb2U before a job avoids a returned part that almost fits.
You can find out more via Plumb2U.
Toilet seat hinges look like one of the simplest parts on the whole cistern-and-pan setup, right up until the wrong replacement arrives and will not line up with the holes already drilled into the pan. Two fixing systems dominate the UK market, top-fix and bottom-fix, and they are not interchangeable without redrilling the pan, which nobody wants to do.
The lever type matters too. Close-coupled cisterns almost always use a side lever or a push button through the lid, while older low-level suites more often run a side lever connected by an external link arm. Ordering a replacement lever without checking which type is fitted is a common cause of parts being sent back.
On button-actuated cisterns with a rigid spindle, the button sits directly above a plastic or metal rod that passes through the cistern lid and connects to a lever arm on the flush valve below. Pressing the small button rotates or depresses the spindle partially, lifting the flush valve seal just enough for a short flush. Pressing the full button pushes the spindle further, lifting the valve completely so the cistern empties in one go. Wear at the point where the spindle meets the flush valve lever is the most common failure here, often showing up as a button that clicks but produces no flush, or a short flush that no longer fires at all while the full flush still works.
When sourcing a replacement, the button, spindle or cable and flush valve should be treated as a connected set rather than assumed to be interchangeable across brands, since fixing centres, spindle diameters and cable lengths vary between manufacturers. Plumb2U stocks dual-flush buttons, spindles, cables and the flush valves they operate, at trade prices, so a plumber can source the whole linkage in one order rather than guessing which single part will solve a button that has stopped working properly. Checking the range at a plumbers merchants like Plumb2U before a job avoids a returned part that almost fits.
You can find out more via Plumb2U.
Toilet seat hinges look like one of the simplest parts on the whole cistern-and-pan setup, right up until the wrong replacement arrives and will not line up with the holes already drilled into the pan. Two fixing systems dominate the UK market, top-fix and bottom-fix, and they are not interchangeable without redrilling the pan, which nobody wants to do.
The lever type matters too. Close-coupled cisterns almost always use a side lever or a push button through the lid, while older low-level suites more often run a side lever connected by an external link arm. Ordering a replacement lever without checking which type is fitted is a common cause of parts being sent back.
On button-actuated cisterns with a rigid spindle, the button sits directly above a plastic or metal rod that passes through the cistern lid and connects to a lever arm on the flush valve below. Pressing the small button rotates or depresses the spindle partially, lifting the flush valve seal just enough for a short flush. Pressing the full button pushes the spindle further, lifting the valve completely so the cistern empties in one go. Wear at the point where the spindle meets the flush valve lever is the most common failure here, often showing up as a button that clicks but produces no flush, or a short flush that no longer fires at all while the full flush still works.