A bottom-entry fill valve, by contrast, takes its supply vertically through the base of the cistern, in line with where a rising main or supply pipe comes straight up from the floor void or from beneath a low-level suite. This arrangement is generally quieter, since the incoming water enters below the surface of the tank rather than splashing in from the side, which is why many modern and replacement fill valves are built as bottom-entry as standard, often with a side-entry option built into the same body.
Fixing centres, meaning the distance between the two mounting holes in the pan, is the measurement that actually determines whether a seat will fit at all, and it varies enough between manufacturers that assuming a standard spacing is a common source of returned parts. The two most frequently seen spacings in the Plumb2U UK are around 140mm to 145mm and 160mm to 165mm centre to centre, and a seat bought for the wrong spacing simply will not sit over both holes.
The first check is timing. A whistling or high-pitched noise that happens throughout the entire fill cycle, easing off only as the cistern nears full, usually points to wear inside the fill valve itself, most often a perished washer or a worn diaphragm that is no longer sealing smoothly against the valve seat. Water forced through a narrowed or roughened opening produces exactly this kind of noise, and it tends to get worse over time rather than appearing suddenly.
Learn more at water softener supplier UK.
Measuring before ordering saves a return trip: the thread diameter of the existing lever body, the distance from the lever mounting to the flush valve connection point, and whether the arm needs to sit above or below the water line all affect which replacement will actually fit. A lever bought to the wrong thread size will not seal against the cistern wall, however well the rest of the job goes.
The flush valve tells a different story. If water is draining slowly from the cistern into the pan even when nobody has touched the button or handle, the flush valve seal or siphon washer has likely perished and is no longer sealing the outlet at the base of the tank. This shows up as a cistern that refills every few minutes with no obvious trigger, sometimes described by customers as topping itself up rather than running continuously. On older gravity-fed systems built around a siphon rather than a valve, a split diaphragm inside the siphon body produces the same symptom.
Fixing centres, meaning the distance between the two mounting holes in the pan, is the measurement that actually determines whether a seat will fit at all, and it varies enough between manufacturers that assuming a standard spacing is a common source of returned parts. The two most frequently seen spacings in the Plumb2U UK are around 140mm to 145mm and 160mm to 165mm centre to centre, and a seat bought for the wrong spacing simply will not sit over both holes.
The first check is timing. A whistling or high-pitched noise that happens throughout the entire fill cycle, easing off only as the cistern nears full, usually points to wear inside the fill valve itself, most often a perished washer or a worn diaphragm that is no longer sealing smoothly against the valve seat. Water forced through a narrowed or roughened opening produces exactly this kind of noise, and it tends to get worse over time rather than appearing suddenly.
Learn more at water softener supplier UK.
Measuring before ordering saves a return trip: the thread diameter of the existing lever body, the distance from the lever mounting to the flush valve connection point, and whether the arm needs to sit above or below the water line all affect which replacement will actually fit. A lever bought to the wrong thread size will not seal against the cistern wall, however well the rest of the job goes.
The flush valve tells a different story. If water is draining slowly from the cistern into the pan even when nobody has touched the button or handle, the flush valve seal or siphon washer has likely perished and is no longer sealing the outlet at the base of the tank. This shows up as a cistern that refills every few minutes with no obvious trigger, sometimes described by customers as topping itself up rather than running continuously. On older gravity-fed systems built around a siphon rather than a valve, a split diaphragm inside the siphon body produces the same symptom.